Boat Building Forum
Find advice on all aspects of building your own kayak, canoe or any lightweight boats
Re: S&G: Building a Point Bennett 18
In Response To: S&G: Building a Point Bennett 18 (Sodbuster------WebKitFormBoundary6pLaVD9X7Zfw4+Pi-)
: If I decide to use non-marine plywood it is 8 feet long. Marine ply
: is 8' 2 1/2" long, correct? This means I should add 2 1/2
: inches to the bow end side panels, correct? Thanks in advance.
No. The marine ply is longer, but it has markings stamped on the ends for the grade of plywood and the BS numbers etc. You will want to cut the ends off so as not to have the markings on your yak. I built the PB 15'9" and cut them to the exact measurements in Duane's lofting. Came out fine.
Charles Robinson
Messages In This Thread
- S&G: Building a Point Bennett 18
Sodbuster------WebKitFormBoundary6pLaVD9X7Zfw4+Pi- -- 8/6/2010, 9:59 am- Re: S&G: Building a Point Bennett 18
Paul G. Jacobson -- 8/8/2010, 12:29 am- Re: S&G: Building a Point Bennett 18
Sodbuster------WebKitFormBoundary6pLaVD9X7Zfw4+Pi- -- 8/9/2010, 11:30 pm- Re: S&G: Building a Point Bennett 18
Bill Hamm -- 8/12/2010, 1:20 am
- Re: S&G: Building a Point Bennett 18
- Re: S&G: Building a Point Bennett 18
Charles Robinson -- 8/6/2010, 8:23 pm- Re: S&G: Building a Point Bennett 18
Sodbuster------WebKitFormBoundary6pLaVD9X7Zfw4+Pi- -- 8/6/2010, 8:43 pm- Re: S&G: Building a Point Bennett 18
Bill Hamm -- 8/7/2010, 1:41 am
- Re: S&G: Building a Point Bennett 18
- Re: S&G: Building a Point Bennett 18
Eric -- 8/6/2010, 2:43 pm- Re: S&G: Building a Point Bennett 18
Mike Bielski -- 8/6/2010, 7:12 pm
- Re: S&G: Building a Point Bennett 18
- Re: S&G: Building a Point Bennett 18
