Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Strip: Joining deck and hull question
By:Randy Echtinaw
Date: 2/26/2012, 9:31 am
In Response To: Re: Strip: Joining deck and hull question (Etienne Muller)

: I should perhaps have mentioned that in the above picture the
: bulkheads are already in place, filleted into the hull and
: sanded, ready for filleting, at the deck. I get to that through
: the hatches etc afterwards.

: Et

Etienne, this is exactly what I did and I have been wishing I hadn't. I will not be able to apply tape to the inside joint from the bow and stern to the first bulkheads as there is no longer any access. How did you solve this problem?
Thank you,
Randy

Messages In This Thread

Strip: Joining deck and hull question
righty22 -- 2/25/2012, 7:52 pm
Re: Strip: Joining deck and hull question
Pedro Almeida -- 2/25/2012, 9:45 pm
Re: Strip: Joining deck and hull question
righty22 -- 2/25/2012, 9:48 pm
Re: Strip: Joining deck and hull question
Pedro Almeida -- 2/25/2012, 10:11 pm
Re: Strip: Joining deck and hull question
Jay Babina -- 2/26/2012, 8:09 am
Correction...
Jay Babina -- 2/26/2012, 9:12 am
Re: Strip: Joining deck and hull question
Nick Riccardi -- 2/26/2012, 11:52 am
Re: Strip: Joining deck and hull question
Allan -- 2/26/2012, 3:25 pm
Re: Strip: Joining deck and hull question *PIC*
Etienne Muller -- 2/26/2012, 5:43 am
Re: Strip: Joining deck and hull question
Etienne Muller -- 2/26/2012, 5:45 am
Re: Strip: Joining deck and hull question
Randy Echtinaw -- 2/26/2012, 9:31 am
Re: Strip: Joining deck and hull question *PIC*
Yostwerks -- 2/26/2012, 10:49 am
Re: Strip: Joining deck and hull question
Etienne Muller -- 2/26/2012, 1:07 pm
Re: Strip: Joining deck and hull question
Randy Echtinaw -- 2/26/2012, 3:12 pm