Boat Building Forum

Find advice on all aspects of building your own kayak, canoe or any lightweight boats

Re: Paddle: Favorite finish
By:Sean Dawe
Date: 7/10/2012, 8:47 am
In Response To: Paddle: Favorite finish (Smith)

I go with just tung oil - with enough coats to build up a nice satin sheen. I don't like the look/feel of high gloss. It's too slippery for my liking.

I think you'd have to put on a fair bit of epoxy before you get much in the way of dent resistance. But then again, if you paddle gets dinged, then so be it. It's just like you boat - at some point you're either going to ding or scratch it!!

I look upon the finish as mostly a way to keep the water from soaking into the paddle and, in the case of oil finishes, to bring out the natural beauty of the wood grain.

Just my 2 cents,

Sean

Messages In This Thread

Paddle: Favorite finish
Smith -- 7/8/2012, 4:16 pm
Re: Paddle: Favorite finish
Mike Bielski -- 7/8/2012, 6:00 pm
Re: Paddle: Favorite finish *PIC*
Kurt Maurer -- 7/8/2012, 7:15 pm
Re: Paddle: Favorite finish
Bill Hamm -- 7/9/2012, 2:36 am
Re: Paddle: Favorite finish
risto -- 7/9/2012, 4:28 am
Re: Paddle: Favorite finish
Brian Nystrom -- 7/9/2012, 6:22 am
Re: Paddle: Favorite finish
Mike Savage -- 7/9/2012, 9:50 am
Re: Paddle: Favorite finish
Bryan k -- 7/9/2012, 10:32 am
Re: Paddle: Favorite finish
John Abercrombie -- 7/9/2012, 12:27 pm
Re: Paddle: Favorite finish
Mike Savage -- 7/10/2012, 2:12 pm
Re: Paddle: Favorite finish
John Abercrombie -- 7/10/2012, 7:12 pm
Re: Paddle: Favorite finish
Brian Nystrom -- 7/10/2012, 7:04 am
Re: Paddle: Favorite finish
Mike Savage -- 7/10/2012, 2:30 pm
Re: Paddle: Favorite finish
Mike Bielski -- 7/9/2012, 1:39 pm
Re: Paddle: Favorite finish
Bill Hamm -- 7/10/2012, 1:23 am
Re: Paddle: Favorite finish
Aaron -- 7/10/2012, 12:07 am
Re: Paddle: Favorite finish
Bill Hamm -- 7/10/2012, 1:26 am
Re: Paddle: Favorite finish
Brian Nystrom -- 7/10/2012, 7:08 am
Re: Paddle: Favorite finish
Sean Dawe -- 7/10/2012, 8:47 am
Re: Paddle: Favorite finish *PIC*
Etienne Muller -- 7/10/2012, 3:16 pm