Date: 3/29/2001, 10:31 am
: Greetings,
: I set my glassed Georgian Bay out on the lawn today and then set the glassed
: deck on so I could take some cockpit orientation measurements. Too my
: surprise the deck is a full inch short. I built solid stem and stern and
: the deck doesn't reach to either.
Hey Stan,
My deck was 1/2" short, I just split the difference between the bow and stern and started taping the halves together. It seemed to stretch a little and I ended up with about an 1/8" gap to fill between the deck and end piece at both bow and stern.
No one even notices it until I point it out.....I've got to get out of the habit of pointing out all of my mistakes. They seem so obvious to me.
No fair catching up so fast.
Messages In This Thread
- Deck and Hull joining problem
Stan Snapp -- 3/29/2001, 1:37 am- Re: Deck and Hull joining problem
David Hanson -- 3/30/2001, 8:17 am- Re: Deck and Hull joining problem
Rob Macks -- 3/29/2001, 11:29 am- Re: Deck and Hull joining problem
Stan Snapp -- 3/29/2001, 12:02 pm
- Re: Deck and Hull joining problem
Ben Staley -- 3/29/2001, 10:31 am- Re: Deck and Hull joining problem
Rob Macks -- 3/29/2001, 8:47 am- Re: Deck and Hull joining problem
Kent LeBoutillier -- 3/29/2001, 6:20 am- Re Flames
Elliott -- 3/29/2001, 8:38 am- Re: Re Flames
Kent LeBoutillier -- 3/29/2001, 11:38 am- Re: Re Flames
Scott Henshaw -- 3/29/2001, 12:54 pm
- Re: Re Flames
- Re: Re Flames
- Re: Deck and Hull joining problem *Pic*
John Monfoe -- 3/29/2001, 6:01 am - Re: Deck and Hull joining problem
- Re: Deck and Hull joining problem